Aluminum alloy skirting board is a relatively new type of decorative material. It has the characteristics of good decoration, high strength, strong flexibility, simplicity and fashion.It is currently a popular decorative material. Many people are not familiar with aluminum alloy skirting board. The following is a detailed introduction to the installation method and precautions for aluminum alloy skirting line.
1. Basic treatment
Before installing the aluminum alloy skirting line, pay attention to the basic treatment work. You should observe whether the ground and the wall are flat. Otherwise,1. Basic treatment
the skirting line on the installation will be bent and uneven, and it will not fit on the wall, and there will be ugly gaps, so it is necessary to do a good job in the grassroots treatment.
2.The drilling should be precise
First saw a section of 15 cm long aluminum alloy skirting line, clamp the buckle on the slot on the
back, mark the hole for the buckle against the wall, then use special tools to drill
holes in the wall, and then use plastic Nail it into the hole you just made, and pay attention to fix the buckle on the wall with screws.
3. Treatment of Accessories for Aluminum skirting baseboard
It is very troublesome to deal with the aluminum alloy baseboard at the inner and outer corners. The corners protruding from the wall are called outer corners, and the recessed
corners are called inner corners. When installing the skirting line at the inner and outer corners, pay attention to it. Draw the position of the fixed point on the wall, then take holes,
nail plastic nails, and then fix the inner and outer angle to the corner with screws.
4. Installation
Finally, use a tape measure to measure the size distance of each section, use a cutting machine to cut out the corresponding size, and clip it on the corresponding buckle. The length
of each aluminum alloy skirting line is 3 meters. When the wall exceeds the length of the skirting line, a buckle should be installed in the middle of the interface, so as to ensure
the smoothness of the skirting line.
More detailed installation, please see our installation video：
PS: Introduction to the installation precautions of aluminum alloy skirting boards:
(1) Control the connection gap
When installing the aluminum alloy baseboard, pay attention to controlling the connection gap between the baseboard and the floor. Generally, the maximum gap between
the baseboard and the floor cannot exceed 3 mm. You can use a 1 yuan coin to plug it in. If more than two coins go in, it means that the gap is too large and needs to be
reprocessed.
(2). Dealing with details
The details of the installation of aluminum alloy skirting boards must not be ignored. Before installation, the wall with white cement should be shoveled clean, and then
the skirting boards should be paved. After the paving is completed, protective measures must be taken. In order to prevent the paint from sticking to the surface of the
skirting line due to painting or spraying, it is necessary to do a good job of cleaning in time.
